How to Repair a Garage Door Spring Replacement

Garage door springs and cables are usually two independent units of a garage door mechanism. But they function together and make sure that your garage door always opens and closes correctly. Actually, to operate without any glitches, your garage door must have a kinetic system which would prevent the weight of heavy garage doors from affecting the balance.

If you think that it is only the springs that need repair, then think again. It is very likely that you will also need to have a broken spring or cables due to some damage that has happened in the past. You may not be able to see any signs of damage, but there could be a few. For example, if the garage door springs were abused severely, there may be bent areas or breaks. There are other signs like rusted fasteners or even loose connections which could also mean that you need a higher quality replacement spring.

This is not really something you should mess with yourself. However, if you cannot find the proper repair company for garage springs, you can try to do it on your own. However, doing repairs by yourself can be dangerous, as you have to take extra caution and be careful not to hurt yourself when you are working on something as complicated as garage doors. This is why you should call for professional help when you feel that the repair cannot be done correctly.

The first thing you have to do for garage door springs and cables repair is to find out where the break is happening. Of course, the first place you should check is your garage door opener. If there are damages on the cables, it means that there are also damages on your garage door springs. You need to replace the damaged cables first, and then proceed with the repair on the springs.

There are different ways on how to repair the cables on your garage door opener. It would depend on the damage caused on the cables, on what kind of damage it has, and how much money you are willing to spend for garage door spring repair. If the damage is small and can be fixed with little effort, you can try to fix it with the help of some pliers. You can start by unbolting the tensioner from the door’s tensioner pulley system. Remove it carefully and set it aside.

After that, it is time to disassemble your door. Take note that you should not forget the cables on the tracks. Then, it would be easier to locate their broken connections. Once you have located the broken cables, you should reconnect them with the help of new tension cables. Make sure that the tensioner pulley is properly aligned to avoid garage door springs replacement.

Leave a Reply

Your email address will not be published. Required fields are marked *